Viewing:
Homepage
Garage & Workshop
Inta-lok Garage Floor Tiles

Inta-lok Garage Floor Tiles

Inta-lok Garage Floor Tiles > Dark Grey
Inta-lok Garage Floor Tiles > Black
From £28.55
per square metre (4 tiles)
DIY Fit DIY Fit
Durable Durable
Use Indoors Use Indoors

Summary
Specification
Images (4)
Questions (1)
Reviews

Inta-lok tiles are made from 100% virgin (recyclable) injection moulded PVC and can be laid over any hard surface with minimum or no surface preparation.  The tiles are loose laid on the floor and are easily knocked into place using a rubber mallet.  No special tools are required for installation, just a mallet, sharp knife, tape measure and chalk line. These tiles have a Diamond Plate surface design.

In applications of extreme temperature fluctuations please contact us for advice.  Areas subject to direct sunlight may require fixing with adhesive.

Inta-lok tiles are 4mm thick and measure 508mm x 508mm, packed 8 tiles to a box.  Edges and corners are also available.

Technical Specification

Tech Spec Standard Unit of Measure Inter-lok
Material PVC SG 1.37
Hardness ISO868 Shore A 80
Abrasion DIN5304

Nmn²

 15
Wear Resistance DIN5316

nm³

 87.9
Flame spread DIN51960 Class 1
Fire Resistance

ANSI/ASTM

E648 979

A/NFPA 235

1995 Critical Red

Flus

 Class 1
Electrical resistance DIN 53582 Ohms 1X1014
Anti-slip ASTMC 1028/89 Co-efficient of Very Good
Dimensional Stability NF EN404 % 0.40

Standard Indentation

under load

1.30

 

 
Sound absorbtion db up to 46 db up to 40db
Thermal resistant BS4745 Good
Thermal Conductivity Good

Uses

The Inta-lok tile has many uses from Nurseries to Gyms and Sports Halls as well as Garages and Retail Outlets.

The joining mechanism is virtually invisible when tiles of the same colour are joined together.  When tiles of different colours are joined, the mechanism creates an attractive 'jigsaw' type pattern.

Inta-lok tiles are made from 100% virgin (recyclable) injection moulded PVC and can be laid over any hard surface with minimum or no surface preparation.  The tiles are loose laid on the floor and are easily knocked into place using a rubber mallet.  No special tools are required for installation, just a mallet, sharp knife, tape measure and chalk line.

In applications of extreme temperature fluctuations please contact us for advice.  Areas subject to direct sunlight may require fixing with adhesive.

Inta-lok tiles are 4mm thick and measure 508mm x 508mm, packed 8 tiles to a box.  Edges and corners are also available.

0 stars No reviews have been written yet

Share your thoughts with other customers… write your own review

How is the edge finished at the wall and the entrance?

Hello Mr Hanson

Thank you for your enquiry.

The Inta-lok pvc tile should be cut approx 10-15mm around the perimeter to allow for thermal expansion. With regards to the entrance a transitional rampedge is available with the same ' jigsaw' connections as per the tile.

I hope this helps with your enquiry.

Regards

The Tact Team

Ask a question about this Product